This type of glue is specifically made for the production of skateboards or a high quality of woodwork glue can also be used. This glue is used to glue plys togather.
Skateboard Mould.
The veneer is then placed into a mould that will shape the deck to the required. It will also help the process when the veneer is placed into a press. The veneer is now placed into a skateboard press to maintain the shape, should be a cold press (no heat, room pressure)
Drilling
A standard pillar drill is used to drill the holes for the screws to attach other components.
shaping the skateboard
Shaping the deck is often accomplished by using another deck as a template. Use a band saw or jig saw to cut out the deck.
Routing and Sanding the Skateboard
The way a skateboard deck gets it's radiused or rounded edges can be achieved by using a router or a lot of sanding.Once you've gotten the edges taken care of, you'll want to sand your skateboard deck. It is helpful but not necessary to use an orbital sander.Start with 80 or 100 grit sandpaper and progressively work your way down to about 220 grit sandpaper which should leave the deck very smooth.
sealing the skateboard
Once the deck has been sanded smooth, use a tack cloth to remove the saw dust left behind.There are many different products you could use here, from Deft Lacquer to specialty products like Gemini Coatings WB-0230.
Graphics
After you've applied the sealer, you can move on to the graphics Stencil, spray paint, free hand or screen print.
Final coat
Once you have finished your graphics and you've left them to dry overnight or longer, take your tack cloth and wipe down the deck. Depending on the product, you may want to give your skateboard several more coats of finish Using a clear coat